2013 GMC Sierra 2500 HD
Mileage
199,854
Service Date
3/17/2020
Services Performed
- Alignment
- BALL JOINT – Remove & Replace – 4WD Lower,Both – [DOES NOT include alignment.]
- BALL JOINT – Remove & Replace – 4WD Upper,Both – [Serviced with Control Arm.] – [DOES NOT include alignment.]
- CALIPER – Remove & Replace – Front,Both – [Includes: Perform ABS Automated Bleed procedure.] – [Includes: Bleed System and replace Pads (if necessary).]
- CALIPER – Remove & Replace – Rear,Both – [Includes: Perform ABS Automated Bleed procedure.] – [Includes: Bleed System and replace Pads (if necessary).]
- IDLER ARM – Remove & Replace – w/o Skid Plate – [DOES NOT include alignment.]
- OUTPUT SHAFT SEAL – Remove & Replace – Front,Both – [Includes: R&I Drive Axle Housing.]
- PITMAN ARM – Remove & Replace – Gas – [Includes: R&I Steering Gear Assembly. Includes: R&I Stabilizer Bar.] – [DOES NOT include alignment.]
- TIE ROD &/OR END – Remove & Replace – Recirculating Ball Type Gears Inner,Both – [Includes: R&I Outer Tie Rod Ends.] – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion
- TIE ROD &/OR END – Remove & Replace – Recirculating Ball Type Gears Outer,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie
Chad P. gave our service a 5 star review on 3/18/2020
